G2 Throttle Cam System

G2 Challenge:  Improve control in changing conditions for moto and off-road.

G2 Solution:  The Throttle Cam System.

The Throttle Cam System incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening.  The “pulley”, or as we call it, “cam” pulls the throttle cable as the rider rotates the grip/tube.  By altering the conventional, circular shaped cam, a vast improvement in control is achieved.

The Throttle Cam System has cam options with reduced radius for the first ½ of throttle rotation, which requires a slightly farther turn to achieve the same carburetor or throttle body opening position as a stock throttle.  This slightly longer pull makes a HUGE difference in rider control as the power is rolled on.  The system comes with a “100CAM” – same as stock, “200CAM” – starts out 10% smaller than stock and “400CAM” – starts out 20% smaller than stock.  The radius of the 200CAM and 400CAM increases or “ramps up” to stock size at  ½ throttle to keep overall rotation required to reach full throttle at or near stock rotation.

G2 Key Points:    

• Machined from 6061 aluminum in the USA!
• Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel
• Alternate cams to fine tune control sold separately
• Fits inside the stock throttle housing to stock cables
• Slide one of our Domino grips (sold separately) or your grip unto the included Throttle Tube
• Removable end cap for simple handguard installation
• Installs in minutes!