G2 Throttle Tamer for Dirt Bikes

G2 Challenge:  Offer one throttle set-up for best overall performance in all off-road conditions.

G2 Solution:  The Throttle Tamer.

The Throttle Tamer incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening.  The “pulley”, or as we call it, “cam” pulls the throttle cable as the rider rotates the grip/tube.  By altering the conventional, circular shaped cam, a vast improvement in control is achieved.

The Throttle Tamer has a cam with a reduced radius initially, which requires a slightly farther rotation to achieve the same carburetor or throttle body opening position as a stock throttle.  This slightly longer pull makes a HUGE difference in control as the power is rolled on and the rider searches for traction.  The radius increases or “ramps up” after ½ throttle to keep overall rotation requires to reach full throttle at or near stock rotation.

G2 Key Points:    

• Machined from 6061 aluminum in the USA!
• Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel.
• Included cams: A 400 cam that starts out approximately 15% smaller than stock.
• Fits inside the stock throttle housing to stock cables.
• Slide one of our Domino grips (sold separately) or your grip unto the included Throttle Tube.
• Removable end cap for simple handguard installation.
• Installs in minutes!