G2 Street Tamer Throttle Tube

G2 Challenge:  Improve control of over-responsive power characteristics of most fuel injected motorcycles.

G2 Solution:  The Throttle Tamer.

The Throttle Tamer incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening.  The “pulley”, or as we call it, “cam” pulls the throttle cable as the rider rotates the grip/tube.  By altering the conventional, circular shaped cam, a vast improvement in control is achieved.

The Throttle Tamer has a cam with a reduced radius initially, which requires a slightly farther rotation to achieve the same carburetor or throttle body opening position as a stock throttle.  This virtually eliminates the jerky “throttle snatch” especially evident in modern fuel injected street bikes.  The radius increases or “ramps up” after ½ throttle to keep overall rotation requires to reach full throttle at or near stock rotation.



G2 Key Points:    

• Machined from 6061 aluminum in the USA!
• Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel.
• Included cam is removable and can be replaced with alternate cams (sold separately) to fine tune control.
• Fits inside the stock throttle housing to stock cables.
• Works with all known aftermarket cruise controls.
• Slide one of our Domino grips or your grip unto the Throttle Tamer.
• Installs in minutes!