 |
We
recommend that you ride and evaluate the TCS before
competition to try the three cams and feel how
each effects your control. For best results, try
on a track as similar as possible to your normal
racing conditions.
Your
Throttle Cam System includes three cams (CAM100/200/400).
The CAM100 is similar to your stock cam. The
CAM200 has a “cammed” shape with
a slightly smaller radius in the first 1/4 turn
of the throttle. The CAM400 has a more pronounced “cam” shape
with an even smaller radius for the first 1/4
turn of the throttle.
For
best results, start with the CAM400. This will
show the maximum amount of control with the system.
After a few laps, change to the CAM100 (stock).
Going back to the stock feel will provide a point
of reference and demonstrate the advantage of
this system. Now try the CAM200. For the remainder
of your test session, switch cams several times
to feel which cam works best in different conditions.
This is crucial to teach yourself which cam to
choose for different conditions. |
 |
| 1) Attach
cam to tube with grip securely installed. It is recommended
that grip glue is used and safety wire installed.
Allow time for glue to properly set per manufacturers
recommendations. |
| CAM100
- installation is same as stock. |
| 2) With
engine turned off, slide tube/cam onto handlebar
and attach throttle housing. Tighten bolts on housing
to manufacturers recommendation. |
| 3) Insert
throttle cable into throttle housing and attach barrel
of inner throttle cable to cable "keyhole" on
CAM100 with the small top throttle housing cover
removed. Next, install cable pulley and top throttle
housing cover per manufactuers recommendations. |
| 4) Adjust
throttle cable free play per manufacturers recommendation
before operation. |
| CAM200/400
- Installation instructions. |
| 1) With
engine turned off, slide tube/cam onto handlebar. |
| 2) Insert
throttle cable into top half of throttle housing
(not attached to the handlebar). |
| 3) Pull
inner cable as far as possible and hold with thumb
(see picture) - similar to technique used to attach
throttle cable to carburetor slide. |
| 4) Insert
inner throttle cable end barrel into cable "keyhole" on
CAM200/400. |
| 5) Attach
throttle housing to handlebar, install cable pulley
and top throttle housing cover per manufactuers recommendations. |
6) Adjust
throttle cable free play per manufacturers recommendation
before operation. |
|
